CAD training for facilities management CAD
training for facilities management
Keeping a
floor layout up to date with changes after a contractor has producded "As fitted" drawings of their installation, is a logical requirement when CAD software is used in facilities management. Manual editing requires time to edit the layout with the changes.
Time can be saved however, but the features to do this are not typically covered in basic
training centre courses.
Indeed if such a question arises on a basic course, a delegate will be advised
to attend an additional intermediate course.
In-house
cad training can therefore avoid the cost of attending both basic and
intermediate courses , because content is not restricted to the basics, it’s
focused on your CAD work.
An easier and more rewarding method of learning for
your colleagues.
Training can be from beginner or refresher, remote one to one only where trainer can see your screen throughout, or in small groups on your premises.
Call free phone 0800-1976281 to discuss with a trainer or email [email protected]
