Troubleshooting Design Centre and Tool palettes (DC) You can drag and drop blocks from the Design centre into your drawing.
The design centre has 2 tabs. One for open drawings and the folders tab to access drawings on your accessible drives including your server drives.
One of the problems that can occur is looking for a block for example in the wrong drawing on the left. Change to the correct drawing listed before accessing the blocks tab.
Bear in mind that blocks will be dragged onto the current layer. So if that layer is turned off or frozen they will disappear.Another reason for blocks disappearing is if their insertion point has not been picked. This will leave the insertion point at it's default 0,0. A Zoom extents (Z, then E) will probably show them at the bottom left hand corner of your drawing.
For individual or almost individual attention in small group training - click here
Personal email support currently £45 per month with no contract : email info@autocadtraining.co.uk